Page 1 of 1
Electricians splicing twistie
Posted: Sat Aug 06, 2005 3:34 pm
by Jimpson
You can buy a pack of electricians splicing twistiesand sand them down to fit your barrel. SOme have "wings" that need sanding. THey have metal threaded inserts inside too so you could screw a dowl rod inside and make a kind of dart. Or you could freeze water in the cavity.
Ethan
Posted: Sat Aug 06, 2005 4:37 pm
by CS
That might work but just take your barrel to a hardware store and start shoving things down your barrel (screws, washers, etc) and you have a 99% chance of finding some cheap exact size ammo. I found three diffrent things that fit perfectly (no wadding) in my pneumatic one was these blue screw 11 cents, then i found these little metal pieces for masonary work 9 cents, and i also found these little plastic things that were like 4 cents. I think it would be alot easier my way but the twisties would definetly work.
Posted: Sat Aug 06, 2005 8:48 pm
by saladtossser
nice, really creative.
Posted: Thu Jan 05, 2006 9:06 pm
by toza
That might work but just take your barrel to a hardware store and start shoving things down your barrel (screws, washers, etc) and you have a 99% chance of finding some cheap exact size ammo.
if i did that at my local hardware store i think they would call the cops!!!!!!
you can just go to a place wear a house is being built they have alot of stuff lying around in boxes you can always find things there and its cheap!!!!!!