SpudFiles

does any one now or tested how high a kolbalt standerd blow gun can go
will it work at 900psi i really need to now wont say any wre has never been tested

please if any one now please comment

Wow 900 psi . I have used mine up to 400psi with no problems.

900 PSI?

Id say 500 is the limit.... What compells you to use 900 PSI and a blowgun anyway? (im curious and exited )

I personally stray away from shop blowguns at higher pressures. Its easier to jsut youse a BV. Not to mention I dont trust those blowguns.....

sorry to bring up old threads im attempting to build a cheaper version of this the wasphttp://www.waspknife.com/about.php i wanted to use a un regulated 12 gram adapter (any one now were to get one)
i already built the knife part and i was goin to use the blow gun a a valve

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.

should i use a 1/4 bv for it instead of a blowgun

does any body now wear to get the 12 gram adapter that screw into a 3/4 coupling

seriously start with something simpler and safer... even much lower pressures can be dangerous... when a pressure hose ruptures near you at 300 psi you'll know what I mean...

blowguns are cheap and designed to work at 150 psi (ussualy)... using them at 500 psi is already pushing the limits a little too much... you have to understand that some stuff might work ok above their pressure rating... but 'might' does not mean they always work...

I might be wrong but I think you are simply irresponsible

i perfictly agree that im irresponsible but should i use a ball valve that safe right
any one now were to get those co2 adaptere like the one in the picture below
[img]
--------------------------------------------------------------------------------

cadside.jpg
Description:

Filesize: 9.83 KB
Viewed: 5410 Time(s)


[/img]

They start to leak at higher pressures...
and I believe that the discussion of making such a device is against forum rules.

i would say no to using a blowgun at that high pressure, so a pressure washer handle or ball valve would be your other options.

900psi for a standard blowgun?

I say go for it. They haven't handed out the Darwin Awards yet this year, and I'd say you'd be a shoo-in.

i tried it leaked really badly then i guess the rubber seal went it releasd i sounded like a 50 cal goin off right next to you even with protaction


i dont no for sure because i used a really old blow gun it was atleast 5 years old dont nowq if it had effect but in the first second it started to leak really bad the it just went it was so scary sounded like a bomb went off never doin that agion


warning never do this with out proper safty equpment espically ear protection
sorry if mispelled

So seven people said no, but you still went for it? Why did you even ask?

i am a really stuntman

twizi wrote:i am a really stuntman

No, just another dumbass