Hey all, so I'm considering making a mini to shoot 6mm ball bearings. I have an ASCO 1/8" 3 way QEV valve like this one.
http://www.indautomation.com/pdf/asco/qexhausts.pdf
I had a design all planned out, but then I realized that it may not seal if I fill it from the chamber side like I want to. Do you guys think it would work?
Thanks,
Ammo
QEV Compatibility Question
-
Gun Freak
- Lieutenant 5
- Posts: 4971
- Joined: Mon Jan 25, 2010 4:38 pm
- Location: Florida
- Been thanked: 8 times
If there is not a spring in the back, add one, then poke a hole in the diaphragm. If there is already a spring then all you need to do is poke the hole and it should be good. Use a needle to poke a very small hole.
OG Anti-Hybrid
One man's trash is a true Spudder's treasure!
Golf Ball Cannon "Superna" ■ M16 BBMG ■ Pengun ■ Hammer Valve Airsoft Sniper ■ High Pressure .22 Coax
Holy Shat!
One man's trash is a true Spudder's treasure!
Golf Ball Cannon "Superna" ■ M16 BBMG ■ Pengun ■ Hammer Valve Airsoft Sniper ■ High Pressure .22 Coax
Holy Shat!
Where exactly would I be poking this hole? The diaphragm has a large gap around it. Here is a couple pics. (Crappy cell pics, but it was in my pocket.)
-
Technician1002
- Captain
- Posts: 5189
- Joined: Sat Apr 04, 2009 11:10 am
The very small hole would go from the pilot area to the chamber area so the pressure can balance between them as the chamber is filled. Do not put a hole out to the barrel from the pilot. That would be bad.
Oh, so shouldn't be good then? There is about a 1/16th gap all the way around the diaphragm as it is.
EDIT: NVM, I see what you are saying. I just looked at the other side... Duh..
EDIT: NVM, I see what you are saying. I just looked at the other side... Duh..