So when I fill it to anything over 120PSI the blow gun get stuck shut and I cant fire it. Any solutions? All Iv had to do so far is press the pressure releaf button on the side not shown, but I would prefer to pull the trigger.
Blow Gun Malfunction.
-
LucyInTheSky
- Specialist 2
- Posts: 293
- Joined: Fri Apr 21, 2006 11:46 am
This is the blow gun which acts as the fill/exhaust for my quick exhaust valve. It fills from the bottom then I disconnect the compressor and pull the trigger an it lets pressure out the bottom. Problem is it isnt ment to store pressure on the top side and let it out the bottom, its ment the let it out the top.
So when I fill it to anything over 120PSI the blow gun get stuck shut and I cant fire it. Any solutions? All Iv had to do so far is press the pressure releaf button on the side not shown, but I would prefer to pull the trigger.
So when I fill it to anything over 120PSI the blow gun get stuck shut and I cant fire it. Any solutions? All Iv had to do so far is press the pressure releaf button on the side not shown, but I would prefer to pull the trigger.
If your getting chased off a police dog, try not to run through a tunnel then onto a small see-saw then through a ring of fire. They are trained for that!
-
schmanman
- Staff Sergeant 2
- Posts: 1685
- Joined: Sat Mar 25, 2006 12:28 pm
- Location: Michigan,U.S.A
- Contact:
take it off,and attach the side attached to the compressor to the gun,so you flip the direction of flow. that seems like a lot of extra work,why don't you just continue hitting the pressure relief button on the side ?
Persistence is a measure of faith in yourself
-
LucyInTheSky
- Specialist 2
- Posts: 293
- Joined: Fri Apr 21, 2006 11:46 am
I will probly and it is only when I get past 8BAR.
If your getting chased off a police dog, try not to run through a tunnel then onto a small see-saw then through a ring of fire. They are trained for that!
