SpudFiles

hi everyone this is my second atempt at a Pneumatic gun i hope you all like it.

Chamber3/4" galvanized steel pipe
valve 1" sprinkler valve modded
barrel 8mmx1m aluminium tube

i have not fired the gun yet but i have pumped it up to 10 psi just to c if valve worked and it fired like my ball valve gun did at 160 psi lol. i'll try get some damage pics up tomomorow

You need a stock to shoulder it, nice build!

ya i'll make a stock tomorrow if stop having fun shooting it lol

hey great gun... I like the fact that you used a BV to make it breach loading

you should consider upgrading it to a 1/2" QEV and building a fridge compressor to use higher pressures

That's quite good! Take a bow.

I would add another barrel support closer to the end of the chamber.

Are you loading ammo through the ball valve at the rear?


Edit: Ahh, Poland Spud you Fast Fingered Freddy you!

hey nice gun mate!

Love the use of the BV

oh and GO FORD

@Gippeto sorry

@sinper2006 you built a very nice gun... have fun using it for a while... but when you decide to upgrade it replace that sprinkler valve - it's the only part that stops you from using 30 bar

That is a very nice gun.. What did you use for the barrel? also what size.I know you can get brass pipe nipples in custom lenghts. There perfectly smooth on the inside, no seam. You should upgrade to a stronger valve so you can take it up to higher psi..other wise the galvnized pipe is just over kill.

when i get some more money i'm thinking of getting a brss solenoid valve i have seen some rated to 1500 psi. my barrel is 10mm od 8mm id aluminium tube glude into a 10mm nipple

Ooohh cool haha.

Too bad the sprinkler limits it to 150

it doesn't really matter bout valve coz i only got bout 20 m to shoot but i'll get a new valve one day

well have fun with it for a while
threaded parts give you the possiblility to upgrade it whenever you want to so its up to you whether you change the valve or not

i only got bout 20 m to shoot

that's more than enough

Nice job. Neat and trim unit there, not much to complain about. I agree with jrrdw, a stock would round it out.

hahaha niceee gun mann
how are u loading up the ammo ??
and get some more pictures onto it, looks great !!!!

i load wad/darts in ball valve and stick bbs, lead, screws down barrel
i'll put up some more pics in a min just need to resize them