SpudFiles

This is my first working piston cannon and my first post on spudfiles.

I usually only pump this up to around 90 - 100psi and i made two barrels.
- 1 1/4" potato barrel - 2" sleeved into 2"PVC (golfball barrel)

Specs:
- 2" chamber
- modded sprinkler valve (pilot valve)
- plywood piston (i got the idea from MrCrowly)

shot a golf ball 350+ yards

Nice cannon! And welcome to spudfiles. It looks a little akward to hold though.

yea. its really meant to be held by your hip but it is a little different

Cool, And I think You topic isnt getting much attention is because It was titled the same as mine, and most people have already seen mine, so You might want to change the topic title.

Cool cannon, is that gray stuff leak sealant?

ehh. its ok. thanks though

umm no. it epoxy putty. after i finished it there was a small leak there but now its fine.

i like the cannon but i see some DWV --- i one on the pilot is a easy fix but the one on the front is going to be a hard fix and maybe a cannon ender


p.s. you should drill and tap your psi gauge on a fitting so you more then just one layer of pvc

oh no. i think i might just leave it because i never take it over 100psi and its hasnt broken yet. you're right though, i really should fix it.

100 PSI is still a hell of alot of pressure on non-pressure rated fittings, I would say around 60-80 psi, just to be safe, because we all know how catastrophic it is when PVC ruptures.

yea. ive never had PVC break, but ive heard some crazy stories. thanks for the heads up though

nice cannon, and i have a input on the DWV, you have it on the worst possible places since those fittings take the smack of the piston

you're right. i think i might actually fix it now cuz i dont want to die next time i shoot this thing.