SpudFiles

i need one that works well if any one has made one that does not allow more than one paint ball at a time to go into the chamber that is what im looking for but ill take anything i can get........

there was one cannon i saw on here that had a hopper. But can i find it? edit: no. can you just buy a hopper from a real paint ball gun?

Thats exactly what I though, spend $5 or less and buy a regular paintball hopper.

Make one out of PVC

yea. if you can, save your time and money and go and buy one.

Buy one, they're cheaper, probably work better, and all that other stuff. They fit perfectly in 3/4" T's.

yes thanks but when the hopper is feeding the paint balls.... i don't want more than one paint ball getting into the chamber at a time .........has any one had success with doing that or is there no way around it ..... oh and is there a way to keep the paint balls from rolling out of the barrel

Just put a ball detent in there.
It will solve both problems.

Drill a TINY hole,
cut off some brissles off a toothbrush. Put them in the hole. Put some hotglue to hold them. They should go about 1/3 the way into the chamber max.

What you need is a bolt. A bolt is something that goes forward when you shoot to block the flow of air into the hopper. If you want this to be semi automatic go here: http://www.spudfiles.com/forums/gb-semi-t7899.html
He made one that's a little tricky to make.

If you don't mind caulking it, you could make one that you manual move back and forth to load the next paintball.

You need to stop air flow into the hopper so the paintballs don't go flying straight up which they will.

I think you could make this into a hopper one http://www.spudfiles.com/forums/small-a ... e-t12.html or you could makeit into a magazine.

do you have the plans for a manual bolt action chamber ......plz if you do or know where one is at I'd like to know

its just something that is the size of your chamber, that is hollow that has a rod attached to it that allows it to slide back and forth and locks in both positions.

Can you understand this? I drew this up awhile ago.

ok thanks ...... you draw that on a napkin???...... well thanks any ways

truth 3570. At first I tried to make my own pvc hopper. I got two 45 degree joints of 2" and a short piece of 2" pvc (approx 3" of it) I bored a hole about 3/4" into the pvc and made a joint to go down to the chamber. I put a screw cap on the one end of the 2" and endcap on the other end. This works pretty well whilst also using a bolt system. I get no jams either. It worrks, but I suggest you buy one! [/img]