Page 1 of 1
sealing a bike/car valve
Posted: Fri Mar 23, 2007 7:26 pm
by mattf
hey guys in new here and i'm making a marble shooting air gun and i need 2 pump the air chamber up to 140 psi or at least 100. and i don't know how to put the valve on the end of a PVC lid without is blowing my face off any suggestions???
Posted: Fri Mar 23, 2007 7:27 pm
by noname
Drill a hole in the cap and pull the valve through, do some research.
Posted: Fri Mar 23, 2007 7:33 pm
by mattf
r u sure that'll hold it tho?
Posted: Fri Mar 23, 2007 7:35 pm
by shud_b_rite
Simple, drill a hole big enough for the pin end to go through but not big enough for the whole valve to go through. Then whack some epoxy on it.
Posted: Fri Mar 23, 2007 7:43 pm
by Mr.Russ
is it one with a notch in it? if it is just drill a 12.5mm hole in the end cap and pull it through, it will use a bit of effort. but it will not come out or leak.
why is this in the bbmg discussion?
Posted: Fri Mar 23, 2007 8:15 pm
by itwentboom
DO some RESEARCH and when your done RESEARCH again.
Posted: Fri Mar 23, 2007 10:50 pm
by willarddaniels
Previous thread on valve stems
Several of us posted a lot regarding this matter, check out the link provided above.