Bic pengun
-
jackssmirkingrevenge
- Five Star General
- Posts: 26183
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 547 times
- Been thanked: 326 times
Nice effort! Solid rubber pistons are easy to make but at high pressures they do have their disadvantages due to the lack of rigidity.
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
TrollingCluckster123
- Recruit
- Posts: 2
- Joined: Mon Nov 10, 2014 5:26 pm
400 psi in a plastic pen? That is not a good idea. Those pens are kind of brittle, so if one failed in your hand it would hurt a lot and also cause serious injury. Please use SCH 40 steel pipe for those pressures.
-
mark.f
- Sergeant Major 4
- Posts: 3628
- Joined: Sat May 06, 2006 11:18 am
- Location: The Big Steezy
- Has thanked: 52 times
- Been thanked: 53 times
- Contact:
He's using brass tubing, not the actual pen.
In regards to your other post, before you bring it up, there are a lot of things not rated for pressure that we use anyway... not always the right thing to do, but we're all adults capable of making a guided decision. For instance: a lot of the higher mixture hybrids we have on the sight are made from non-pressure rated parts, or parts par past their pressure rating.
In regards to your other post, before you bring it up, there are a lot of things not rated for pressure that we use anyway... not always the right thing to do, but we're all adults capable of making a guided decision. For instance: a lot of the higher mixture hybrids we have on the sight are made from non-pressure rated parts, or parts par past their pressure rating.