Page 1 of 1
First mini. How bad is it! horrible.
Posted: Wed Jul 11, 2007 12:30 am
by Alchy_Bang
First mini. pill bottle, and a pen tube. touch hole for ignition. made a dart out a Q-tip and a staple.
Modiefied it this morning to shoot air soft BB's an stuck a sparker on it
Posted: Wed Jul 11, 2007 12:48 am
by Pete Zaria
I've sure seen worse...
Upgrade the ignition. Having an open hole in the chamber seriously reduces performance. Besides that, pretty run-of-the-mill mini. Keep at it.
Peace,
Pete Zaria.
Posted: Wed Jul 11, 2007 6:27 am
by psycix
It looks nice and harmless
Wire a small piezo through the hole and put duct tape over it.
Then it will perform better i think
Posted: Wed Jul 11, 2007 11:53 am
by Fnord
That first picture confused me a lot. The first thing I noticed(after the gun) was the strange ghostly figure at the top. At first I though you might have taken the picture through a window, but then I noticed the gun's shadow wasn't lined up right.
Finally I saw everything appeared to be floating 3 inches above the surface, and only then realized it was on a glass table
Nice first. Good work not getting hotglue/electrical tape everywhere.
Posted: Wed Jul 11, 2007 12:14 pm
by spud yeti
As Pete said, Ive seen a lot worse!
btw, fnord, that is a glass plated table with a TV reflection on it as far as I can see... am I right? (the shadow out of place: and this could be an eastern creation, where levitation of spudguns is quite common...
)
But nice work and keep it up!