Just a quick question, would a 1/8" slide check rated to 16 BAR take unregged co2?
Would I be better off getting one for paintball, would it have enough flow when exhausting to pilot a 1/8" QEV?
Dave
Slide check?
16 bar is around 230 psi
"unregged" co2 is depending on the temp around 700-900
you should be able to find one for what you need on mcmaster.
"unregged" co2 is depending on the temp around 700-900
you should be able to find one for what you need on mcmaster.
Marvin the Martian: Where's the kaboom? There was supposed to be an earth-shattering kaboom!
Marvin the Martian: The Earth? Oh, the Earth will be gone in just a few seconds.
Marvin the Martian: The Earth? Oh, the Earth will be gone in just a few seconds.
PCGUY wrote:Congrats, your the first donating member I have had to ban.
-
john bunsenburner
- Sergeant 5
- Posts: 1446
- Joined: Sun Oct 19, 2008 5:13 am
a lttle thread hj jack: How much pressure an an average blowgun hold, at what pressure can you not open it anymore?
"Did you ever stop to think that out of the seven deadly sins envy is the only one which doesn't give the sinner even momentary pleasure"-George Will
if it's only rated for 16 bar, then no it would not take unregged co2 as unregged co2 is around 850 psi.Dave_424 wrote:Just a quick question, would a 1/8" slide check rated to 16 BAR take unregged co2?
Would I be better off getting one for paintball, would it have enough flow when exhausting to pilot a 1/8" QEV?
Dave
yes a paintball one would better cause it will handle the pressure, it would have same flow rate as the other one.
where did you find a QEV that will take 850 psi ?