Page 1 of 1
Electronic Rain Bird Solenoid Problems! Help!
Posted: Sat May 06, 2006 10:49 am
by tguass04
I have recently attempted to use the typical Rain Bird Valve in my pneumatic cannon and use the solenoid to control flow. I can get the solenoid to open but I do not think it opens enough for the air to flow through fast enough. Has anyone had any similar problems or know what the heck is going on?!
Posted: Sat May 06, 2006 11:15 am
by saladtossser
first check the flow adjustment thingy
second, using a solenoid does not give good results, i suggest modifing it to be pneumatically triggered
third, whats the size of your gun and whats the pressure you are using at?
Posted: Sat May 06, 2006 11:20 am
by SpudStuff
The solonoid is either on or off there is no grey area in between
Posted: Sat May 06, 2006 11:24 am
by tguass04
My Chamber is 1.5"x13" and I am using about 40psi through a 3/4" Rain Bird Valve out to a 3/4" barrell about 18" long.
Posted: Sat May 06, 2006 11:26 am
by tguass04
Even if I leave the solonoid open the entire time it seem like the vavle hesitates and does not release quickly enough.
Posted: Sat May 06, 2006 11:57 am
by SpudStuff
have you moded it internally
Posted: Sat May 06, 2006 1:20 pm
by tguass04
No I have just left it stock.
Posted: Sat May 06, 2006 8:48 pm
by screamingflea
Is it over and under ("U" shaped) or inline? If over/under, be sure the flow control is open all the way. For both types, try shooting it manually twisting the solenoid), you get much more power than electronic. Try taking it to a higher PSI. And you said it shot slow with the solenoid open, what exactly do you mean, if you fill it witht he solenoid open then air will just go out the barrel.
Posted: Sat May 06, 2006 10:59 pm
by tguass04
It is an inline valve. I have shot it at 45 psi and it still has the same problem. I just dont know whats going on man!
Posted: Sat May 06, 2006 11:16 pm
by Benny
only 45? you can go much higher pressure than that.