Like the name says I want to make a cannon that will shoot cans of soda, i can't find any details on what the diameter of a soda can is, does anyone know what size of pipe fits soda cans well? 
Shooting Canns of soda
Well you should get a ruler or tape measure and measure it.
um...... a coke can I just measured with a ruler is bang on 6cm.
I think if you're an American that's about 2.36 inches.
BTW, if you want a pipe for a barrel that fit's a can well then just go to your hardware store with a can and see what pipe fits it exactly or very close too, or you can just take the measurements.
good luck! Hope to see this cannon in the future.
Happy SPuddin'
um...... a coke can I just measured with a ruler is bang on 6cm.
I think if you're an American that's about 2.36 inches.
BTW, if you want a pipe for a barrel that fit's a can well then just go to your hardware store with a can and see what pipe fits it exactly or very close too, or you can just take the measurements.
good luck! Hope to see this cannon in the future.
Happy SPuddin'
Poo.
-
thespeedycicada
- Specialist 4
- Posts: 429
- Joined: Sun Aug 12, 2007 1:28 am
try a tennis ball barrel it sould fit.
current projects: co-axial piston valve.Status DONE!
S.P.E.C.S update mk 1 construction begining in febuary all the maths for it are done plans are drawn up and parts are listed.
NEXT project:auto piston valve.
S.P.E.C.S update mk 1 construction begining in febuary all the maths for it are done plans are drawn up and parts are listed.
NEXT project:auto piston valve.
-
boilingleadbath
- Staff Sergeant 2
- Posts: 1635
- Joined: Sat Mar 12, 2005 10:35 pm
- Location: Pennsylvania, USA
There's a wiki article on the topic, ya know...