That just means I need a larger pilot hole to vent it...
I'm going to remake this valve tomorrow I think... I need to buy 10 feet of 2" PVC though... It's only $1.73 for a 2" Tee (Slip x Thread x Slip) at Lowes... Then $11 or so for 10' of 2" NSF-PW...
How is your piston serviceable? If your piston seals the inside of a 2" tee, wouldn't it bee too big for a 2" pipe? Or does the 1-1/4" coupler fit well in 2" pipe?
I may make the next attempt a 1.5" barrel porting if I seal it like yours... I may just keep it non-serviceable, but with a 2" to 1" (slip x thread) bushing instead of an end plug for the backside...
If I'm going to make it serviceable with a piston that fits 2" pipe, I'll need to buy a 2" female, a 2" male, and a 2" to 1" (slip x thread)... What's the point in making it serviceable, if I can make another whole valve for the price of a 2" female and 2" male
