blow gun presure

[twizi]

i agree i am a dumbass stupid ass and of course jackass


i am awsome

[FordGtMan]

Using unregged co2? Good luck getting that blowguns rubber seals to not freeze.

seriously start with something simpler and safer... even much lower pressures can be dangerous... when a pressure hose ruptures near you at 300 psi you'll know what I mean...

I agree. I have had hose blow out on my leg because of a rupture. It actually hurt like crap.
What other guns have you made twizi? And how did you get the blowgun to 900 psi? Because im sure you have a hpa tank ready to go in your garage..

[twizi]

i got it up with scuba tank with a regulater on it

no i only have three helum tanks i found them in a junk yard
wonder if i could build a cannon out of them??

[Daltonultra]

I agree. I have had hose blow out on my leg because of a rupture. It actually hurt like crap.
What other guns have you made twizi? And how did you get the blowgun to 900 psi? Because im sure you have a hpa tank ready to go in your garage..

Heh, I had a cheap quick-connect from a ShopForce compressor fail a few weeks back. Damn thing went through a cardboard box.

Compressed air isn't something you want to take lightly.

[Xxplosive42o]

900 psi is a bit over the edge. Sorry for the late comment, but I wasn't paying attention when I read the PSI you listed. THAT IS INSANE!

Good luck with that and be careful!

8) 8) 8) 8) 8)

[Hydra]

Hey guys, at least he did it with protection.
Hes not 'just another dumbass"

[twizi]

thank you hydra when i did this i had eye protection on and ear protection and it was in a locker and i was in side my house


see the scuba tank is in side there a hose connected to it that lead to the locker i atached to the blow gun a locked the locker ran inside the house turned on the video camera ps had video camra in locker

then turned on the scuba tank valve and watched every thing on my plasma screen

[POLAND_SPUD]

care to post the video ? I'd love to see it