(Mods feel free to move this if this should belong elsewhere)
Ok, I've got to know how you do it. As a challenge to myself I decided to forgo my lathe and attempt an O-ring cut using just my drill press. The guides and the cuts are easily attempted using machinist files, however, due to the play (back and forth motion) of the piston, my cuts aren't even slightly precise. I end up with cuts shallow on one side and perfect on the other.
I have mad respect for anyone attempting this. Any advice would be appreciated.
Poor Man's Lathe (DrillPress)
Have you ever tried using an extra long carriage bolt so that you could run one end into the chuck, pass through the piston, and then into a drilled end cap (the end cap being mounted in a vise on the press table)? I think this may balance the rotation a bit.
Lol, I've done this successfuly with a dremel for making groves for orings in small scale robots and such to use as wheels. Never tried with a drill press how ever I never noticed play in a press, would your's happen to be a piece of shit?
Whoever appeals to the law against his fellow man is either a fool or a coward.
Whoever cannot take care of themself without that law is both.
For a wounded man shall say to his assailant,
'If I live, I will kill you. If I die, You are forgiven.'
Such is the rule of honor.
Whoever cannot take care of themself without that law is both.
For a wounded man shall say to his assailant,
'If I live, I will kill you. If I die, You are forgiven.'
Such is the rule of honor.
-
squeaks
- Specialist 3
- Posts: 326
- Joined: Sun Oct 01, 2006 5:45 pm
- Location: Enoch, UT(next to Cedar City)
well, our drill press has a hole in the stand just big enough to fit a washer snuggly in it. I figure if I wanted to I could turn ours into a "lathe" by puting a bolt on top and bottom with the top in the chuck and the bottom having the washer fit in this hole.
-
boilingleadbath
- Staff Sergeant 2
- Posts: 1635
- Joined: Sat Mar 12, 2005 10:35 pm
- Location: Pennsylvania, USA
The issue is most likely not that it's acctualy "wobbling" - but simply that it's not stuck on there perfectly strait.
And yeah, the chucked end won't deviate from it's center very much... I believe the term "run out" is used when refering to this attribute in a mill, and it'll be around a few thousandths of an inch.
Carefull turning between centers - what squeaks suggested - will help if you manage to chuck it properly, or if you manage to drill an exactly centered hole in the opposite end.
If you need everything to be exactly cocentric, you could machine it from oversize starting materials. This might be difficult to do without a proper lathe, but I can't tell you, as I've never done it.
And yeah, the chucked end won't deviate from it's center very much... I believe the term "run out" is used when refering to this attribute in a mill, and it'll be around a few thousandths of an inch.
Carefull turning between centers - what squeaks suggested - will help if you manage to chuck it properly, or if you manage to drill an exactly centered hole in the opposite end.
If you need everything to be exactly cocentric, you could machine it from oversize starting materials. This might be difficult to do without a proper lathe, but I can't tell you, as I've never done it.
